Others Wear Rod Application Chart - Snowmobile Wear Rods

Aftermarket ski Wear Rods Application Chart

To prevent cross-threading, rotate the nut counter-clockwise until you feel the end of the nut's thread fall over the end thread of the bolt. Then, turn clockwise to tighten.

Do not over tighten nuts! Tighten only until firmly snug. This is especially important when working with plastic skis. They always have a cushioned feel to them, unlike steel skis which provide a dead stop to the nut. We use 5/16" x 18 bolts because these are all that is necessary - strength-wise. Having more than one bolt only helps keep the host bar straight. Also, this allows the easiest installation without any need to drill the skis or use a hammer. It is not the size of the bolts, but the number and location that is important. Easy installation

To specify Triple Point Carbide models, replace the Good 'n Ugly prefix C or CH with TP

For example: C-B13 becomes TP-B13 or CH6-B12 becomes TP6-B12

Pricing Info	4"	6"	8"
Triple Point Carbide	NA	TP6	TP8
Good 'n Ugly - single carbide	C	CH6	CH8

Model numbers shown below are for Good n Ugly single carbides only.

Make/Model/Year	4"	6"	8"
Arrow	C-K25	CH6-K25	CH8-K25
Blade	C-BLD	CH6-BLD	CH8-BLD

C&A - P	C-C&A-P	CH6-C&A-P	CH8-C&A-P
C&A - Advantage Sport - 2002	C&A-AS	C&A-AS	C&A-AS
C&A - Out Law	C-A-C&OL	CH6-C&A-OL	CH8-C&A-OL

Camoplast Blowmolded	C-K26	CH6-K26	CH8-K26

Curve Ski	C-CRV	CH6-CRV	CH8-CRV

Simmons - Gen 1 & 2	C-SIM	CH6-SIM	CH8-SIM
Simmons - Gen 3	C-SIM3	CH6-SIM3	CH8-SIM3

SLP - Ultra-Lite	C-SLP-UL	CH6-SLP-UL	CH8-SLP-UL
SLP - Straight Line Tracking	C-SLP-L	CH6-SLP-L	CH8-SLP-L
SLP - Powder Pro	C-SLP-L	CH6-SLP-L	CH8-SLP-L
SLP - MowHawk	C-SLP-MH	CH6-SLP-MH	CH8-SLP-MH

SLYDOG	C-SLY	CH6-SLY	CH8-SLY

Split-Rail	C-K25	CH6-K25	CH8-K25

Ultra III	C-C&A-P	CH6-C&A-P	CH8-C&A-P

USI Ski	X	X	X
All models (except rockered) 4-bolt		CH6-USI-2	CH8-USI-2
VX301 5-bolt	C-USI-3	CH6-USI-3	CH8-USI-3

Home | Others Wear Rod Drawings | Ski Savers Chart | Trail Grabbers Chart
Wear Rod Main Page | Site Map