Easier Installation |
|
Easier Installation |
|
 |
||
|
All wear rod brands (except Bergstrom Skegs) require a hammer to install |
||
|
|
||
| Ski-doo Factory Wear Rod |
||
 |
Hammer needed to install! |
|
|
|
||
| Bergstrom Wear Rod |
||
 |
No hammer needed! |
|
|
|
||
| Arctic
Cat Competitor Wear Rods |
||
 |
Hammer needed to install! | |
|
|
||
 |
Hammer needed to install! | |
|
|
||
 |
Hammer needed to install! | |
|
|
||
 |
Hammer needed to install! | |
|
|
||
| Bergstrom Wear Rod |
||
 |
No hammer needed! |
|
|
|
||
|
Hammer and screwdriver needed to remove. | |
|
|
||
| Woody's
Installation Instructions
"It may be required to enlarge the existing holes of your ski due to the heavy-duty fasteners.... This modification can be achieved with a standard drill and a 3/8" bit.... In some applications, it may be necessary to elongate the lead entrance hole of your ski to 1/2". |
Trying to get a 3/8" bolt through a 3/8" hole is not practical. Add to this any slight variation of multiple bolt locations (and the added thickness of plastic skis) and you'll find wear bar installation to be a nightmare! | |
|
|
||
| Smarter Ski Design | ||
|
|
Yamaha's Phazer (1984-1998) ski was a smarter design.
The front bolt hole was round (3/8") while the back three were elongated. The bolts were all 5/16." |
|
|
|
||
| Home |
Arctic Cat Wear Rod
Application Chart | Ski Savers Chart |
Trail Grabbers Chart |
| Site Map |
Copyright © 1999-2016 Bergstrom Skegs, Inc.
All
rights reserved.
